Home > News > Content

Blister Packaging Machine Common Malfunctions

Sep 06, 2017

Blister Packaging Machine Common malfunctions

Common Faults and Solutions of Automatic Blister Packaging Machine

1, covered the appearance of the workpiece is not folded and not smooth or not: the film is not straightened, the film quality is not good, the workpiece grinding is not good, too much glue spray, the workpiece below the touchpad is too low.

2, did not go to the plastic film down: the solenoid valve or hand valve can open.

3, to absorb the phenomenon: the temperature is too high, the heating time is too long, the film quality is not good, no heating.

4, the machine does not start: the input wire nowhere, the power cord reverse, the voltage is not enough.

5, the temperature measurement is not correct: thermocouple, temperature controller. Can not be installed correctly and damaged.

6, the working vacuum does not come: gas barrier, hand valve or solenoid valve is not closed, the vacuum pump motor belt loose, vacuum table damage.

7, the total power switch trip: heating box top input wire leakage, distribution box leakage, the external wire ride on the device, the motor leakage and so on.

8, the suction film is not in place: the vacuum is not enough, the air is not enough, the film is too thin, the workpiece paste the rest of the material, the workpiece deep beyond the film pulled up, the suction time is too short, the film did not pull up, Too close

Automatic use of plastic packaging machine guide

We use the automatic plastic packaging machine, we must pay attention to observe the various operating conditions of the machine is to prevent the emergence of some unnecessary security problems, so there are a few related knowledge to share with you:

1, when the heating work of the automatic operation of the equipment, do not touch the device and name work, the machine will stop working, should be in the furnace after a few minutes, will be manually operated.

2, when the product length is less than 800mm, the mold action or brake action to synchronize the operation, when the local machine, the brake should be the first, in the mold work.

3, when the manual feeding should pay attention to mechanical, mechanical equipment, therefore, in the automatic state or in the manual operation state, while focusing on the automatic state, prohibit the use of hand knife switchgear, to avoid personal injury.

4, when the hand into the machine operation, you must first cut off the power, to avoid harm to the human body accident.

5, in a major job work 2 machines, no head and hand close to the machine, so as to avoid accidents.

6, when the adjustment of the machine in the local work, if the solenoid valve power modulation needs, should pay attention to whether due to power failure, resulting in unnecessary harm.