Home > News > Content

Daily Maintenance Of High Speed Aluminum-plastic blister Packing Machine

Jan 15, 2021

High-speed blister packing machine in the process of operation, timely complete the batch records, operation records, notice at the high temperature of forming, heat sealing parts, be careful burns it is forbidden to use foreign body or reach into moving parts, in order to avoid accidents, regular check, connect to avoid friction and other moving parts and cause damage wire short circuit, leakage forming, heat sealing, indentation, such as components, shoulds not be too great pressure, so as not to affect the service life of the packing machine;

Just boot when high-speed aluminum-plastic blister packing machine, can be appropriately raise the preheating temperature of heating components, after being stable running, and appropriate to trim the preset temperature can guarantee function, in order to protect the heating element, maintain a clean and tidy packing machine is beautiful, not delimit, knock on stainless steel surface, with good thing may not be placed in the sports channels in the clutter protect mould, cutting knife, heat sealing checkered plate in the process of packaging, abnormal operation should be timely downtime, troubleshooting to run again after work, press the abrupt stop switch, close the compressed air and cooling water valve.

Daily repair and maintenance of high-speed aluminum blister packing machine is also very important, the specific method is:

1. Check the parts regularly, once a month, check whether the worm gear, worm, bolts on the lubrication block, bearings and other movable parts are flexible and wear, repair defects should be found in time, and shall not be forced to use.

2, fast aluminum plastic blister packing machine should be put in dry and clean indoor use, not in the atmosphere containing acid and other corrosive gas circulation places to use.

3, adjust the aluminum plastic blister packing machine after use or stop, should take out the rotating drum to clean and brush the remaining powder in the bucket, and then installed, ready for the next use.

4. If you stop using for a long time, you must wipe the whole body of the machine, coat the smooth surface of the machine with antirust oil, and cover it with cloth.