Using capsule aluminum plastic blister packaging machine to package products can improve productivity, reduce labor intensity, meet the needs of large-scale production, and meet the requirements of sanitation. The packaging process includes filling, wrapping, sealing and other main processes, as well as the related pre and post processes, such as cleaning, feeding, stacking and disassembly. In addition, the packaging process also includes measuring or printing date on the package. After the heat sealing blanking is normal, moderately open the ram of the feeder, so that the medicine (tablet capsule, sugar coating) can enter the feeding room. If there is a small amount of missing granules, it can be filled manually. The first precautions when filling granules are: roller pressing hand and hook breaking the aluminum foil. In addition, the forming blister goes to the edge of the pressing roller. If there are missing granules, do not force to fill them again. When the medicine is brought in, it will seriously affect the synchronization and light weight When the aluminum foil is sealed, it should be glued on the die and processed by the blister machine. Put down the upper pressing block of the starting and guiding roller, the temperature of the forming heating plate is in place, and then turn on the host machine. The plastic PVC is formed first, and the forming blister is in line with the hole position of the heat sealing die. Pay attention to the heat sealing die seat, put down the heat sealing die with the handle, and press the aluminum foil, which will drive the blanking. Observe whether the plastic (PVC formed on the surface of the machine board) moves left and right. If there is deviation, adjust the starting and guiding roller seat to adjust the starting and guiding direction. In the daily operation knowledge, you must understand the structural principle of the capsule aluminum plastic packaging machine. The roller of the ejector base is driven by the cam. The up and down travel, the position of the upper cover template is fixed, and the blister is in bad condition. Pay attention to the lower forming die or heat seal to the top dead center, and tighten the column nut. If you don't pay attention to it, it is easy to get rid of it If there is a fault, the roller needle of the ejector base is jammed, and the solution is given. The composite structure is composed of polyester, aluminum foil and polyethylene (PET / Al / PE). It has good printing adaptability and good gas and water barrier to drugs.
The good barrier performance of capsule aluminum plastic blister packaging machine is due to its choice of raw materials aluminum foil and plastic hard piece. The aluminum box has a highly dense metal crystal structure with good barrier and shading properties. Compared with bottled drugs, the advantages of blister packaging Z are easy to carry, saving raw and auxiliary materials, light weight, convenient transportation, good sealing performance, which meet the requirements of environmental protection and green packaging; it can package any special-shaped products, without additional cushioning materials.
The packaged products are transparent and visible, beautiful in appearance, easy to sell, suitable for mechanized and automatic packaging, convenient for modern management, saving manpower, improving efficiency, and can reduce the pollution caused by drugs in the process of carrying and taking. Moreover, the blister packaging is also suitable for gas barrier, moisture permeability, health safety, production efficiency, dosage accuracy and extending the shelf life of drugs It has obvious advantages.
The predetermined sealing and cutting position on the packaging material of the capsule aluminum plastic blister machine may deviate from the correct position, resulting in errors. In order to eliminate the error and achieve the purpose of correct sealing and cutting, the packaging design must consider the problem of automatic positioning, screw down the spherical nut on the indentation cover plate, take down the indentation cover plate and put it on the operating table.
Screw down the fixing screw of the module, take down the movable type, wipe it with 95% ethanol solution, put it into the storage box and store it in the designated cabinet, and install the indentation cover plate on the packaging machine according to the reverse order of disassembly. To solve this problem, the design of continuous photoelectric automatic positioning system is mostly completed according to the positioning mark of packaging materials.